z/VM Virtual Networking Link Aggregation - Show commands for Cisco 6509
The following commands can be used to verify the LACP configuration on a Cisco 6509 switch.
vm6509#show running-config interface port-channel 10
Building configuration...
Current configuration : 119 bytes
!
interface Port-channel10
no ip address
switchport
switchport trunk encapsulation dot1q
switchport mode trunk
end
vm6509#show running-config interface gigabitEthernet 2/23
Building configuration...
Current configuration : 177 bytes
!
interface GigabitEthernet2/23
no ip address
switchport
switchport trunk encapsulation dot1q
switchport mode trunk
channel-protocol lacp
channel-group 10 mode active
end
vm6509#show running-config interface gigabitEthernet 2/24
Building configuration...
Current configuration : 177 bytes
!
interface GigabitEthernet2/24
no ip address
switchport
switchport trunk encapsulation dot1q
switchport mode trunk
channel-protocol lacp
channel-group 10 mode active
end
vm6509#show interfaces gigabitEthernet 2/23 etherchannel
Port state = Up Mstr In-Bndl
Channel group = 10 Mode = Active Gcchange = -
Port-channel = Po10 GC = - Pseudo port-channel = Po10
Port index = 1 Load = 0x40 Protocol = LACP
Flags: S - Device is sending Slow LACPDUs F - Device is sending fast LACPDUs.
A - Device is in active mode. P - Device is in passive mode.
Local information:
LACP port Admin Oper Port Port
Port Flags State Priority Key Key Number State
Gi2/23 SA bndl 32768 0xA 0xA 0x217 0x3D
Partner's information:
Partner Partner LACP Partner Partner Partner Partner Partner
Port Flags State Port Priority Admin Key Oper Key Port Number Port State
Gi2/23 SA bndl 32768 0x0 0x2 0x2 0x3D
Age of the port in the current state: 0d:04h:50m:19s
vm6509#show interfaces gigabitEthernet 2/24 etherchannel
Port state = Up Mstr In-Bndl
Channel group = 10 Mode = Active Gcchange = -
Port-channel = Po10 GC = - Pseudo port-channel = Po10
Port index = 0 Load = 0x80 Protocol = LACP
Flags: S - Device is sending Slow LACPDUs F - Device is sending fast LACPDUs.
A - Device is in active mode. P - Device is in passive mode.
Local information:
LACP port Admin Oper Port Port
Port Flags State Priority Key Key Number State
Gi2/24 SA bndl 32768 0xA 0xA 0x218 0x3D
Partner's information:
Partner Partner LACP Partner Partner Partner Partner Partner
Port Flags State Port Priority Admin Key Oper Key Port Number Port State
Gi2/24 SA bndl 32768 0x0 0x2 0x1 0x3D
Age of the port in the current state: 0d:04h:54m:57s
vm6509#show etherchannel 10 port-channel
Port-channels in the group:
----------------------
Port-channel: Po10 (Primary Aggregator)
------------
Age of the Port-channel = 0d:05h:07m:30s
Logical slot/port = 14/2 Number of ports = 2
Port state = Port-channel Ag-Inuse
Protocol = LACP
Ports in the Port-channel:
Index Load Port EC state No of bits
------+------+------+------------------+-----------
1 40 Gi2/23 Active 1
0 80 Gi2/24 Active 1
Time since last port bundled: 0d:05h:01m:25s Gi2/23
vm6509#show etherchannel summary
Flags: D - down P - in port-channel
I - stand-alone s - suspended
H - Hot-standby (LACP only)
R - Layer3 S - Layer2
U - in use f - failed to allocate aggregator
u - unsuitable for bundling
Number of channel-groups in use: 1
Number of aggregators: 1
Group Port-channel Protocol Ports
------+-------------+-----------+------------------------------------------
10 Po10(SU) LACP Gi2/23(P) Gi2/24(P)
This document is maintained by:
Montana Lee z/VM Development montanalee@ibm.com