|
Programming Interface Information:
This information is NOT intended to be used as Programming Interfaces of z/VM. |
ITRBK
Control Block Contents
ITRBK DSECT
Cross Reference (Contains links to field and bit definitions)
ITRBK Prolog
NAME : HCPITRBK
DESCRIPTION: Host DAT Table Iterator Control Block
DSECT : ITRBK
FUNCTION : Contains information for a specific call to
the Host DAT Table Iterator, HCPHDITR,
particularly parameters and match criteria for
the routine to be called.
LOCATED BY : Local register usage in HCPHDITR and HCPHDITR's
callers
CREATED BY : Callers of HCPHDITR
DELETED BY : Callers of HCPHDITR
SERIALIZED : Local task serialization (only the owning task has
the address of the corresponding ITRBK), called
routine serialization is the responsibility of
HCPHDITR's caller.
RELOCATION CONSIDERATIONS : None
COMMENTS : Used to pass input parameters to HCPHDITR, and
to pass output from the called routine back out
to HCPHDITR's callers. Also used to save HCPHDITR
internal information for lower level iterator
routines (iterator uses recursive descent to
traverse multi-level host DAT tables; by saving
the information in the ITRBK, we only have to
pass one pointer down in a register, instead of
passing everything in registers).
ITRBK Control Block Content
ITRBK DSECT
Hex Dec Type/Val Lng Label (dup) Comments
---- ---- --------- ---- -------------- --------
0000 0 Structure ITRBK Host DAT Table Iterator Control Block
HCPHDITR input parameter section. To be filled in by
callers of HCPHDITR.
0000 0 Signed 8 ITRSVADD HCPHDITR input starting virtual
address. If ITRLVPAG was not
specified, PX and BX bits will be
ignored, the address will be
rounded down to a segment
boundary by HCPHDITR. If ITRLVPAG
was specified, only the BX bits
will be ignored, the address will
be rounded down to a 4K page
boundary HCPHDITR.
0008 8 Signed 8 ITREVADD HCPHDITR input ending virtual
address. If ITRLVPAG was not
specified, PX and BX bits will be
ignored, will be rounded up to
the highest address in the ending
segment (that is, the next higher
segment boundary address minus
one) by HCPHDITR. If ITRLVPAG was
specified, only the BX bits will
be ignored, the address will be
rounded up the highest address in
the ending 4K page (that is, the
next higher 4K page boundary
address minus one) by HCPHDITR.
0010 16 Signed 8 ITRLEVEL (0) Defines iteration target level.
Similar in definition to TT bits
in R*TE/STE, with the addition of
an additional (mutually
exclusive) bit to indicate page
table level iteration.
00000000 ITRLVSEG X'00' ITRLVSEG Iterate at segment
table level
00000004 ITRLVRTT X'04' ITRLVRTT Iterate at region
third table level
00000008 ITRLVRST X'08' ITRLVRST Iterate at region
second table level
0000000C ITRLVRFT X'0C' ITRLVRFT Iterate at region
first table level
00000010 ITRLVPAG X'10' ITRLVPAG Iterate at page
table level
Allowable ITRLEVEL values and corresponding target
levels:
x'0000000000000000' - ITRLVSEG:
Iterate at segment table level
x'0000000000000004' - ITRLVRTT:
Iterate at region third table
level
x'0000000000000008' - ITRLVRST:
Iterate at region second table
level
x'000000000000000C' - ITRLVRFT:
Iterate at region first table
level
x'0000000000000010' - ITRLVPAG:
Iterate at page table level
0010 16 Bitstring 1 * (7) Reserved for IBM use
0017 23 Bitstring 1 ITRLEVB7 Defines iteration target level:
0018 24 Signed 8 ITRCRMBZ HCPHDITR table entry match
criteria "Must Be Zero" bit mask
(if both ITROPTE and ITROPCRI
were specified). Bits which are
one in this mask must be zero in
a table entry for the target
routine to be called for that
table entry.
0020 32 Signed 8 ITRCRMBO HCPHDITR table entry match
criteria "Must Be Ones" bit mask
(if both ITROPTE and ITROPCRI
were specified). Bits which are
one in this mask must also be one
in a table entry for the target
routine to be called for that
table entry.
0028 40 Bitstring 1 ITROPTS Option flags for HCPHDITR
1... .... ITROPTE X'80' ITROPTE Iterate on table
entries at the specified level.
Target routine is called once per
table found at the specified
level which represents virtual
addresses within the input
virtual address range; the table
entry address is passed as an
argument to the target routine.
.1.. .... ITROPTBL X'40' ITROPTBL Iterate on tables
at the specified table level.
Target routine is called once per
table found at the specified
level which represents virtual
addresses within the input
virtual address range; the table
designation is passed as an
argument to the target routine.
Notes : One of ITROPTE or
ITROPTBL *MUST* be specified,
although they are mutually
exclusive. Calls with both or
neither set will result in an
ABEND.
..1. .... ITROPPTV X'20' ITROPPTV Only has meaning
if ITRLEVEL is set to indicate
iteration at the page table
level, or if ITRLEVEL is set to
indicate iteration at the segment
table level with ITROPTE set to
indicate iteration at the segment
table entry level. ITROPPTV set
indicates that any page tables
which have been paged out should
be validated during processing.
...1 .... ITROPCRI X'10' ITROPCRI May only be set if
ITRITTE is also set, to indicate
iteration on table entries. The
ITRCRMBZ and ITRCRMBO inputs
specify table entry match
criteria: ITRCRMBZ is a bit mask
specifying bits which much be
zero in a target table entry for
the entry to be considered a
match (bits which are one in
ITRCRMBZ must be zero in a target
table entry for it to be
considered a match). ITRCRMBO is
a bit mask specifying bits which
much be ones in a target table
entry for the entry to be
considered a match (bits which
are one in ITRCRMBO must also be
one in a target table entry for
it to be considered a match). The
target routine is called only if
the table entry matches the
criteria.
0029 41 Bitstring 1 * (3) reserved for IBM use
002C 44 Signed 4 ITRTARG Address of target routine to be
called for host DAT tables (or
entries) which match the
specified input criteria. Routine
must have attribute SAVE=DYNamic.
0030 48 Bitstring 1 * (4) reserved for IBM use
0034 52 Signed 4 ITRTROPT Target routine R2 parameter
options. Will be passed to the
target routine in R2.
0038 56 Signed 4 ITRTRTOK Target routine parameter token.
Will be passed to the called
routine in R3. If parameters are
to be passed to, or back from,
the called routine, this field
may be used to pass a 32 bit
parameter value, or may be used
to pass the address of a
parameter data area (obtaining,
releasing, and serializing such a
data area is entirely the
responsibility of the caller and
the called routine, not the
iterator).
003C 60 Signed 4 ITRASCBK Address of ASCBK from original
HCPHDITR R8 input.
0040 64 Signed 4 * Reserved for IBM use
HCPHDITR output section. Contains HCPHDITR processing
information for return to HCPHDITR's caller.
0048 72 Signed 8 ITRCALCT Running count of calls made to
the target routine by HCPHDITR.
Is only incremented, is not
initialized to 0 by HCPHDITR,
allowing the caller to use it as
a running count of calls to the
target routine across multiple
invocations of HCPHDITR.
HCPHDITR internal usage section. Should not be used by
callers of HCPHDITR.
0050 80 Bitstring 1 ITRSTAT Iterator status byte
1... .... TRGRTERR X'80' TRGRTERR The target routine
returned a non-zero condition
code or R15 return code
0051 81 Bitstring 1 * (7) Reserved for IBM use
0058 88 Signed 4 ITRTRGCC Target routine condition code
(saved in IPM/SPM format)
005C 92 Signed 4 ITRTRGRC Target routine R15 return code
End of ITRBK
0060 96 Signed 4 ITR$END (0) End of ITRBK control block
00000060 ITRLEN *-ITRBK Length of ITRBK in bytes
0000000C ITRSIZE (ITRLEN+7)/8 Size of ITRBK in
doublewords
ITRBK Storage Layout
*** ITRBK - Host DAT Table Iterator Control Block
*
* +-------------------------------------------------------+
* 0 | ITRSVADD |
* +-------------------------------------------------------+
* 8 | ITREVADD |
* +------------------------------------------------+------+
* 10 |////////////////////////////////////////////////|:LEVB7|
* +------------------------------------------------+------+
* 18 | ITRCRMBZ |
* +-------------------------------------------------------+
* 20 | ITRCRMBO |
* +------+--------------------+---------------------------+
* 28 |:OPTS |////////////////////| ITRTARG |
* +------+--------------------+---------------------------+
* 30 |///////////////////////////| ITRTROPT |
* +---------------------------+---------------------------+
* 38 | ITRTRTOK | ITRASCBK |
* +---------------------------+---------------------------+
* 40 |///////////////////////////|///////////////////////////|
* +---------------------------+---------------------------+
* 48 | ITRCALCT |
* +------+------------------------------------------------+
* 50 |:STAT |////////////////////////////////////////////////|
* +------+--------------------+---------------------------+
* 58 | ITRTRGCC | ITRTRGRC |
* +---------------------------+---------------------------+
*
*** ITRBK - Host DAT Table Iterator Control Block
ITRBK Cross Reference
Symbol Dspl Value -------------- ---- ----- ITR$END 0060 ITRASCBK 003C ITRCALCT 0048 ITRCRMBO 0020 ITRCRMBZ 0018 ITREVADD 0008 ITRLEN 0060 00000060 ITRLEVB7 0017 ITRLEVEL 0010 ITRLVPAG 0010 00000010 ITRLVRFT 0010 0000000C ITRLVRST 0010 00000008 ITRLVRTT 0010 00000004 ITRLVSEG 0010 00000000 ITROPCRI 0028 10 ITROPPTV 0028 20 ITROPTBL 0028 40 ITROPTE 0028 80 ITROPTS 0028 ITRSIZE 0060 0000000C ITRSTAT 0050 ITRSVADD 0000 ITRTARG 002C ITRTRGCC 0058 ITRTRGRC 005C ITRTROPT 0034 ITRTRTOK 0038 TRGRTERR 0050 80
Copyright IBM Corporation, 1990, 2011